Your shopping cart is empty!
CTEC CFP Alarmsense Conventional 4 zone panel Two Wire
- Brand: CTEC
- Product Code: CFP704-2
- Availability: 3-5 Days
£212.40 Inc VAT £177.00 Ex VAT
CTEC CFP AlarmSense Conventional 4 zone panel (Two Wire)
CFP Alarmsense 4 zone, two-wire fire panel.
The CFP704-2 includes four AlarmSense zones, four conventional sounder circuits, class change & alert inputs and onboard fire & fault relays.
A wide range of engineering functions are also provided including selectable zone delays, coincidence and non-latching zone facilities
Includes 4 AlarmSense zone circuits.
Note: requires 2 x 3.4Ah lead acid batteries.
For use only with Apollo AlarmSense two-wire detectors, call points and sounders.
Approvals/certifications Certified to EN54-2/4 by the LPCB (0832-CPR-F0386)
Mains supply 230V 50/60Hz
Mains rated current 350mA maximum
Internal power supply 19V-28.5V (27V nominal). Ripple 7V maximum (battery fault)
Total output current limited to 1.5A @ 230Vac (ImaxA eq 146mA)
Quiescent current 25mA (mains failed, internal sounder active, PSU & gen fault LED lit)
Max battery size and type 2 x 12V 3.2Ah VRLA connected in series. Min. battery size 1.2Ah
No. of detector zone circuits The CFP704-2 has 4 AlarmSense zone circuits which are compatible with Apollo's AlarmSense range of detectors & call points AND sounders & visual indicators. (Max. length per circuit is 500m)
Call point resistor value Only use AlarmSense call points
Max. devices per detector zone 25 AlarmSense detectors/manual call points per AlarmSense zone. For AlarmSense sounder limitations per AlarmSense zone see 'Max. sounder output current' section
No. of conventional sounder circuits 4 - these are additional conventional (non-AlarmSense) sounder circuits; Max. length per circuit is 500m.
EOL resistor value 6800Ω 5% Tol. 0/25W (blue, grey, red, gold)
Alarm voltage 27V max, 20V min (final battery voltage)
Max. sounder output current Each AlarmSense zone circuit & each conventional sounder circuit will support a max. sounder current of 200mA. Distribute sounder loads as evenly as possible. Total sounder loading per panel should not exceed 1.25A
Auxiliary relays Two: (1) Aux. Fire; (2) Fault. Volt free single pole changeover. Max. switch current 1A; Max. switch voltage 30Vdc
Open collector outputs Two: (1) Reset (Active during reset cycle); (2) Remote (Active during any unsilenced fire condition provided all relevant delays have expired). Max. sink current 30mA, Max. open circuit voltage 27Vdc)
Other outputs 24V Aux. Power (Protected by a resettable fuse. 100mA min. hold current. Resets when fault removed)
Expansion connections Yes – for optional network driver cards (one required per repeater system), relay output cards and EN54-13 sounder circuit interface boards
Product dimensions (mm) 380 W x 235 H x D 96mm
Construction & finish Plastic lid and base; RAL7035 textured
IP Rating IP30
Weight 1.75kg (without batteries)